Midi on pads

[Silami]

Hi there.

Another midi problem, I know there's a lot of people asking about that on here.

I'm trying to use my SP606 thru USB as a midicontroller for Traktor Scratch.
The thing is, the midi works(thanks to this forum, for the external/v-link tip). The fx rotary knobs, the MFX1 and MFX2 buttons and the D-beam send midi messages. But that's all.
I can't get my pads to send midi messages, nor the sequencer buttons, the big value rotary/menu scroller, or any other button.

Inside my P606 software, everything works just fine, but I think the P606 does not communicate with midi, but on another level with the SP606.

Anyone else has experienced this, or knows the right settings?

[korakios]

did you "enabled" the note trigerring on the sp?press function and the pad(can't remember which!)?also you must be in external mode....

[DeeJayCtr]

Press EXT

Then press and hold FUNC, and press pad 5 (note trig)

Then its all good in the woods.

Dee Jay CTR

[Silami]

Thank you,. but I found the solution already. Problem was much simpler then I thought.