non sp related problem

QuoteunQuote · Post by **QuoteunQuote** » Thu May 08, 2008 7:26 am

I'm tryin to record into my computer in stereo to Soundforge but I only get input in the left channel, I have the default settings set at stereo in but it still doesnt work. anyoneone know what the problem might be?

drewzle · Post by **drewzle** » Thu May 08, 2008 7:36 am

might be a dodgy cord?

i got these shitty Hosa cords and this happens a bit

niq names · Post by **niq names** » Thu May 08, 2008 1:36 pm

descibe your rig? like in the last post it could be a cord but thats kinda hard to determine without knowing your exact method...man!!!!!

QuoteunQuote · Post by **QuoteunQuote** » Thu May 08, 2008 7:39 pm

I'm running my MPC or 606 1/4 inch stereo out to 1/8 inch single into to audio in on my computer, the sound card is turtle beach I believe

niq names · Post by **niq names** » Thu May 08, 2008 8:25 pm

try usb. i use sound forge and thats how i get a signal in.

try this go to www.asio4all.com and download the drivers. after u do this go to www.rolandus.com and u have to get the drivers from their site if u havent already.

after completion hook your sp in via usb it should take u through the stages. there will be file that starts with RD that needs to be accessed so save the 606 driver file to your desktop. then once thats done

open soundforge and it may or may not say something about your soundcard change. go to the audio section through prefences and youll see your options. if u open that box the roland sp-606 should be listed.

note... when u go to record u have to go to the sp menu in #4 and turn output source to mix!! or u wont get any sound.

only thing i havent tried is midi triggers/controllers with this software. but everything else should work just fine