maybe everybody knows this trick to make the pitch function work as it should...and I was the only one who didn't get it..
I tried on the internal sounds and on samples and it works!
just sample the high pitch and then do the pitch function going from C1 to C, going down, not up.
Use the high algorithm to preserve a better definition on the high frequencies that tend to glitch or blur...
I tried and.. BAM! The samples were OK , no glitch or distortion!
ok...very little glitches and only in some "extreme" samples, but I got good basses, pads, pianos,drums...
on electronic basses using the low algo it sounds better on the low end, while using the hi algo gets better "resonance sounds".
