Alright so i got a dope sample that i chopped......I used setting 5 and the problem im having is....
Ok...when your in the chopping screen testing the settings you can hit the pads numerous times without it playing the whole part of that pad.....Basically cutting it off before it should by hitting the pad again and starting the sample over.........
After I execute the chop and set it to a pad bank, If i hit the pad 4 times its gonna play the whole pad 4 times....In an almost delayed effect.....SHouldnt the sample start over by hitting it again????
Questions about the chopper......
Moderator: TGN
Hmmm not sure what's happening there.....go to the SAMPLE PARAM page and check that the sample parameters are the way you want them. Could be something to do with the gate/shot/loop something-or-other settings.. Try your sample on heaps of different settings until it plays the way you want it to!
As an aside, with the chopper, occasionally there will be a little bit left on the end of a sample, you can fix this in the sample edit section of the 606 by trimming the start and end of the sample. Haven't actually needed to do this yet, but I'm sure the time will come...
As an aside, with the chopper, occasionally there will be a little bit left on the end of a sample, you can fix this in the sample edit section of the 606 by trimming the start and end of the sample. Haven't actually needed to do this yet, but I'm sure the time will come...