sp404sx+KP3=live loops (Beheringer Xenyx cueing?)

[gustavo_tre]

My set is to sample the sp404sx to a Korg KP3+, generate loops and then mix them live, for a long time.
Anyone know if it is possible to cueing (or pre listen sp404sx samples) with a mixer Beheringer XENYX 1200?
Seeking to avoid a dj mixer, to have more channels and connect other devices like mics, synths, etc.
Some advice?????
TKS

[hseiken]

You can totally do this...

Headphones -> 404 headphone jack for monitor.
404 RCA->mixer to change 'output' volume for cue setup
Mixer->kp3.

Turn the volume down on the mixer and your earphones will still play the audio.

You may need to get a cable to go from RCA->1/4" but that's cheaper than a mixer, right?

[gustavo_tre]

you are right, it works....TKS!

[wax inspektor]

i do the same shit - live looping - 404 into KP3 - no need for a mixer in between

-use the 404 headphone out for cueing
-use the MIC/LINE switch on the KP3 to kill the line input when cueing
(when using both mic and line in, just set the input level knob on the kp3 to zero instead)

basicly the same shit hseiken explained - but w/o a mixer in between...

[gustavo_tre]

Thanks a lot, i would love to listen some of your live looping....