is this the right cable for the 404

samp · Post by **samp** » Wed Mar 21, 2007 5:08 pm

To go from my sp404 into my mixer would this be the right cable:

http://www.musiciansfriend.com/product/ ... rc=3WFRWXX

or this one??? :

http://www.samedaymusic.com/product--HOSCPR20

thanks in advance for the help!!! peace and all the best

jsrockit · Post by **jsrockit** » Wed Mar 21, 2007 5:12 pm

It depends on what you are plugging the 404 into. The 404 has RCAs... so you are good with either cable...as long as the device you are plugging the 404 into can accept dual 1/4" or stereo 1/4" ... either will do the job.

samp · Post by **samp** » Wed Mar 21, 2007 6:13 pm

thanks I had the rca cable going into two seperate 1/4 jacks into my mixer. But when listening back to the pan fx I could not hear it panning. I only hear the panning thru the sp404 headphone out?? any clues

jsrockit · Post by **jsrockit** » Thu Mar 22, 2007 12:08 am

If you are going into two mono inserts on your mixer... you're not going to hear the pan effect... at least that's what I think.

pt3r · Post by **pt3r** » Thu Mar 22, 2007 8:12 am

If you connect the 2 outputs of your 404 on 2 mono channels on your mixer then you will need to pan one channel lef t and the other right.

jsrockit · Post by **jsrockit** » Thu Mar 22, 2007 12:39 pm

pt3r wrote:If you connect the 2 outputs of your 404 on 2 mono channels on your mixer then you will need to pan one channel lef t and the other right.

But that will not make the pan effect on the SP-404 work right no?

pt3r · Post by **pt3r** » Fri Mar 23, 2007 10:19 am

No but he will hear it correctly on his mixer.
That is if his 404 is not messed up.

samp · Post by **samp** » Fri Mar 23, 2007 2:51 pm

thanks for the reply's/ So if i get an rca to 1/4 stereo cable then I wont have to pan? thanks again

jsrockit · Post by **jsrockit** » Fri Mar 23, 2007 3:32 pm

As long as your mixer has a set of stereo ins.