Locked myself away for 4 days making tracks, must have trimmed 70+ samples in that time,.. the end result a slightly bent jogger... anyone encountered this and fixed it? i dont wanna open shit unless i know theres a point..
cheers
Went ham on the Jog wheel.. no its bent slighty.
Moderator: TGN
-
Doomrustler
- Member
- Posts: 44
- Joined: Fri Dec 13, 2013 1:37 am
- Location: U.K
- Contact:
Re: Went ham on the Jog wheel.. no its bent slighty.
Well is it still working? Man you must have really pressed hard to bent it>
The only thing I can think of is that if the leads to the pot cause it to raise off the circuit board a lil and then when you pressed too hard it bent those leads resulting in what seems to be a bent jogger wheel.
If it still working just live with it otherwise trying to bend it back can cause a a break in the leads which means you would need to do some soldering.
The only thing I can think of is that if the leads to the pot cause it to raise off the circuit board a lil and then when you pressed too hard it bent those leads resulting in what seems to be a bent jogger wheel.
If it still working just live with it otherwise trying to bend it back can cause a a break in the leads which means you would need to do some soldering.
-
Doomrustler
- Member
- Posts: 44
- Joined: Fri Dec 13, 2013 1:37 am
- Location: U.K
- Contact:
Re: Went ham on the Jog wheel.. no its bent slighty.
still works, just seems to tighten up around 2 o clock then get loose again around 8 o clock, with a wobble on it... i wernt pushing hard but i was speed trimming... good advice and thanks!!
PEace
PEace