Looping issues

[Dr Van Nostrand]

keep one looping and trigger the other one live every time around, you could resample them together looping and mark out a section where it sounds best and loop that up, or use the pattern sequencer to place them in a pattern of the right length and BPM, and they will be triggered at the same time each go around so it will always sound the same as long as the BPM of the pattern is set right (you have to reset it if you change it for another pattern or turn the machine off)

[gis_sweden]

Stop comparing with KP3 They are very different… You have to resample them together or use pattern sequencer… as Nostrand says. Even if the SP says that the loops are exact the same length, they are not… SP is SP

[sax.appeal]

Thanks Nostrand, I'll give all of that a try!

[Dr Van Nostrand]

not sure what happened to your initial post, or maybe i hit new topic instead of reply by accident?? either way hope you can find a way that works for you

[Krisso The Great]

"SP is SP"
Haha!

Had the same issue .. Offset thunder funk!

[sax.appeal]

I'm not sure either. But basically I'm used to using real time, seamless looping like on the rc-30 and Kp3, so the SP is a new method that I have to get down. I've noticed that a lot of people (samiyam, dibia$e and elaquent) usually have entire tracks assigned to one pad, so this is probably the method I will take, while hitting other pads live when i need them. Also, guy from sweden -I am well aware that the SP is different from the KP3 - that was the point of the initial post.