Anyone else ever had this problem? I took my 303 to a local technician to get soldered when the right output crapped out. The guy assures me the connections are good, and that there must be a bad chip on the operating board somewhere.
If I jiggle the right RCA chord when it's plugged in, I get intermittent sound, and the phones out still works fine. Does anybody work on these things, like is there a Bruce Forat for SPs?
still no output from right RCA out after re-solder job!
Moderator: TGN
-
false tropics
- Member
- Posts: 223
- Joined: Mon Sep 17, 2012 5:26 pm
Re: still no output from right RCA out after re-solder job!
You need a new cable? Stupid question I know. My RCA cables always shit out on me, even the expensive ones.
-
false tropics
- Member
- Posts: 223
- Joined: Mon Sep 17, 2012 5:26 pm
Re: still no output from right RCA out after re-solder job!
I wish it was the cable! I tried a few different ones, same lack of output. Thanks, though!
-
Euclid Ov Oåklånd
- 303 Award Winner '09
- Posts: 4588
- Joined: Sun Jul 01, 2007 12:01 am
- Location: Narnia
Re: still no output from right RCA out after re-solder job!
Well you could open up the 303 and visually verify if the technician actually soldered the rca outputs to the board, if so was it done sloppy/poorly? If so I would call the shop that repaired it and ask if I could bring it in to show them. If the work was done properly but genuinely did not remedy the problem I would just record from the headphone out, if that output does not work then I would suspect something more serious is occurring. Hope that helps some.
