SP-FORUMS

hello everyone.

I'm new on the forum.




I bought an SP-404 A, one month ago.


I'm here today a bit sadly.

If I choose a bank ie: E/J or C/H etc... and I play the pads (from these banks after A/F ) .

The pads 4, 8, 12, 11 on the SP, the bank's change and go to the A/F bank .

I'm a bit afraid of an issue with pads (electronic or whatever)

So, I have to try to format the SD card and test if it's not an issue of storage's sapce.

this week end I learned the "pattern" mode, it was interesting. Before that I was more 'resample mode'.

I would dig pattern mode today but it seems dead.

Thanks.

did i understand right, when you switch banks, just a few pads switch sounds?

Hello sorry, I thought it was clear.

I play pads from example, the last banks, and the sp switch bank, going to the first bank.


But yesterday I've formatted the SD card, and put some new samles on it. It seems the issue didn't appears again, though I've not still put samples on last bank.

Last week end I played a lot in pattern mode, sometimes the sp's displayed some pads are 'full'.

I hope the issue is due to something's like 'too much lenght of pattern mode's recordings.'

It seems the issue came from the full memory.

I solved the problem.