Page 1 of 1
Changing volume of separate samples
Posted: Fri Oct 02, 2015 12:42 am
by foxking
what i am looking to do is change the volume of an individual sample using the 555. Im not sure if this a possibility on the, if so help would be appreciated.
love
foxking
Re: Changing volume of separate samples
Posted: Fri Oct 02, 2015 1:57 am
by EndorShores
Hit the start/end/level button up top rightsmall button. The third knob of the effects will change pad level. If u have pads going and want to change level to do fades in and out on a particular pad, hold remain and push the pad you want to effect that will cue it up for any changes. Then hit s/e/l button and use knob three. Knobs one and two fine tune the pad start and end time.
You can also hold down the velocity button and use knob three to dial in a pad velocity. So you can change a pads volume and velocity independent of each other.