mixer, Sp+mpc , speakers

[Champloo]

i want to chop my samples on my mpc 1000 (because its easier on the mpc than the Sp303) and also play my keyboard synth along with it. i want my Sp303 to act as an effects processor for both my mpc 1000 and synth.

i have a 4 channel mixer, that has stereo outputs and a stereo aux out. my question is where do i plug the Sp 303 and speakers up, for this particular setup?

do i plug the aux outs from the mixer into the Sp303 or the main outs of the mixer into the 303?

(basically, i want the 303 to be last in the chain so that my other machines will be running through it to pick up the effects)

thank you guys

[Krisso The Great]

if you're just using the mixer for the speakers then...

keyboard >> MPC >> SP303 >> mixer >> speakers

theres a million ways you could hook your gear up ..

[Unfolding]

2nd. If I had the same setup I'd go stereo ins from the keyboard & MPC into the mixer. Then stereo aux out to the SP-303, which goes stereo in to the MPC. This set up allows resampling via both samplers & keeps the keyboard ready to be sampled by anything.

[Champloo]

i think i have what you guys are saying, like this?

keyboard audio outs >> mixer channel 1
mpc 1000 audio outs >> mixer channel 2
mixer aux outs >> sp 303 inputs
sp 303 outputs >> mpc 1000 record inputs
L/R speakers >> mixer L/R main outs

[Unfolding]

i think i have what you guys are saying, like this?

keyboard audio outs >> mixer channel 1
mpc 1000 audio outs >> mixer channel 2
mixer aux outs >> sp 303 inputs
sp 303 outputs >> mpc 1000 record inputs
L/R speakers >> mixer L/R main outs

Exactly! Hope it works for you too.