Is there a MIDI note for the sampling button?

lotspoop · **Joined:** Wed Jan 16, 2008 9:35 pm **Posts:** 78

I'm kinda new to MIDI but if my understanding is correct, if I can find out the MIDI note for the sampling button (on any sp really) then I could start/stop sampling from some sort of external MIDI device right?

Does anyone know the MIDI implementation for the sampling button? Specifically I'm trying to start/stop the sampling button of an sp-555 with an external footswitch. This is different from the loop capture section.

drewzle · **Posted:** Wed May 14, 2008 11:57 pm

it can't be done with the 404, not sure about the 555. check the MIDI Implementation chart at the back of the manual

lotspoop · **Joined:** Wed Jan 16, 2008 9:35 pm **Posts:** 78

Yeah I've looked at it before but I'm not sure what I'm looking for.
Just Sampling Start = midi number x or something like that?

enossified · **Joined:** Tue May 06, 2008 12:47 pm **Posts:** 47

You'd want to look at the System Exclusive (sys-ex) messages supported by your particular SP.

The 404 and 555 have no sys-ex support of any kind so you're out of luck.

The SP-606 sends sys-ex when you hit the Sample button (in EXT mode only) but does not receive it.

lotspoop · **Joined:** Wed Jan 16, 2008 9:35 pm **Posts:** 78

hmm that's too bad. thanks for the technical info though. i'm still learning about MIDI so that little bit was helpful for clarification

Is there a MIDI note for the sampling button?

Who is online