It is currently Fri Mar 29, 2024 4:48 am




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: Went ham on the Jog wheel.. no its bent slighty.
PostPosted: Wed Mar 12, 2014 7:44 pm 
Member

Joined: Fri Dec 13, 2013 1:37 am
Posts: 44
Location: U.K
Locked myself away for 4 days making tracks, must have trimmed 70+ samples in that time,.. the end result a slightly bent jogger... anyone encountered this and fixed it? i dont wanna open shit unless i know theres a point..

cheers


Offline
 Profile  
Top 
 Post subject: Re: Went ham on the Jog wheel.. no its bent slighty.
PostPosted: Thu Mar 13, 2014 9:11 pm 
Member

Joined: Wed Jan 29, 2014 8:10 pm
Posts: 129
Well is it still working? Man you must have really pressed hard to bent it>

The only thing I can think of is that if the leads to the pot cause it to raise off the circuit board a lil and then when you pressed too hard it bent those leads resulting in what seems to be a bent jogger wheel.

If it still working just live with it otherwise trying to bend it back can cause a a break in the leads which means you would need to do some soldering.


Offline
 Profile  
Top 
 Post subject: Re: Went ham on the Jog wheel.. no its bent slighty.
PostPosted: Fri Mar 14, 2014 12:28 pm 
Member

Joined: Fri Dec 13, 2013 1:37 am
Posts: 44
Location: U.K
still works, just seems to tighten up around 2 o clock then get loose again around 8 o clock, with a wobble on it... i wernt pushing hard but i was speed trimming... good advice and thanks!!

PEace


Offline
 Profile  
Top 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 



Who is online

Users browsing this forum: No registered users and 9 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: